www.rinnai.us
OWNER’S INSTALLATION INFORMATION
IMPORTANT!
All Rinnai water heaters MUST
be installed by a state qualified or
licensed contractor. Failure to comply with your local and state codes
pertaining to water heater installations will void the warranty on said
water heater(s). It is the responsibility of the person having the unit
installed to ensure the contractor has the proper licences and permits
for his state. In addition to the above, Rinnai requires all contractors
attend a product knowledge class before installing our water heaters.
This requirement MUST
be met in order for your product’s warranty to
be valid. Failure to comply with your local and state codes will result
in non-compliance and void the warranty of the product being
installed.
This appliance must be installed in accordance with local codes, or in the
absence of local codes, the National Fuel Gas Code, ANSI Z223.1 and/or the
CAN/CGA-B149, Installation Codes.
Install this product outdoors ONLY, DO NOT install indoors.
Do Not use this appliance if any part has been underwater.
Immediately call a qualified service technician to inspect the appliance
and to replace any part of the control system and any gas control
which has been underwater.
Detailed instructions on the proper installation practices to follow for
the installation of your new continuous hot water heater are included
at the back of this manual.
Model V2532W6
To Next Page
Loading...
Need help?
General