Power Transmission Products 1.0 Safety Tips
3
1.0 GENERAL SAFETY TIPS
SAFETY FIRST
Read and understand this manual before operating the TensionRite®
Belt Frequency Meter.
›
Do not drop meter or subject either meter or optical sensor to other
sharp impact.
›
Do not put water, solvents (including cleaning solutions) or any
other liquid on the unit. Clean meter and sensor with a dry
cotton cloth.
›
Do not pull on sensor cord. Disconnect sensor from meter by
grasping the connector grip only.
›
Do not leave the unit in places that are humid, hot, dust-illed or in
direct sunlight. Hint: When the TensionRite® Belt Frequency Meter is
not to be used for a while, remove the batteries and store unit in the
case provided.
›
Do not use your TensionRite® Belt Frequency Meter in any
potentially explosive environment.
›
Do not disassemble or attempt to modify either the meter or the
sensing head.
LOCK OUT – TAG OUT
Switch o and isolate any belt drive system prior to taking tension
measurements or attempting any other installation work. Switch
o and isolate any belt drive system prior to taking tension
measurements or attempting any other installation work.
To Next Page
Loading...