Contour NEXT ONE - Control Solution Testing Procedure

Control Solution Testing
NOTE: Tightly close the bottle lid immediately after you remove
the test strip.
1. Remove a C
ONTOUR NEXT test strip from the bottle or foil
packet.
2. Insert the grey square end of
the test strip into the test strip
port until the meter beeps.
The meter turns on, displaying a
Ê»ÉÊÉÊÈ¿ÆͿʾ·Ų·É¾¿Ä½
blood drop.
Ɠ¼ʾ¿É¿Éʾ»ŰÈÉÊʿûÏÅË·È»ÅƻĿĽʾ»¹ÅÄÊÈÅÂ
solution, write the date on the bottle.
3. Shake the control solution bottle well,
about 15 times before every use.
Unmixed control solution may cause
inaccurate results.
CAUTION: Do not use control solution that is more than
ʽ ÃÅÄʾÉÆ·ÉÊʾ»º·Ê»ÏÅËŰÈÉÊÅƻĻºʾ»¸ÅÊÊ»Ɣ
49