202D-M-V3.1
Programming
18
Step Comment
CAL 14
4mA Retransmission - whole numbers.
CAL 15
4mA Retransmission - digits after the decimal point.
CAL 14 to CAL 15 represent the flow rate at which 4mA will
be output. If the 4-20mA retransmission is not installed,
these parameters can be ignored.
CAL 16
20mA Retransmission - whole numbers.
CAL 17
20mA Retransmission - digits after the decimal point.
CAL 16 & 17 are the flow rates at which the output will reach
20mA.
CAL 18 Enabling and number of points for linearisation.
‘00’ = Linearity Disabled; ‘02’ - ‘10’ number of points.
If Linearity is enabled by entering a number 02 to 10, then
the programming will request data as per the table below.
Input points are entered in ascending order.
INP 01 Input Frequency ‘01’ whole number
INP .00 Input Frequency ‘01’ digits after decimal point
OUT 01 Scaling Factor ‘01’ whole number
OUT .00 Scaling Factor ‘01’ digits after decimal point
Repeat the above for the remaining scaling factors.
Any frequency greater than that of the last linearity point will
be scaled at the last Scaling Factor.
SOFT
Software Version.
To Next Page
Loading...
