Control Microsystems 5901 - Ilrr=N - DTE-Modem Local Rate Reporting

5901 High Speed Dialup Modem Hardware Manual
October 19, 2007
55
2 Circuit 133 (Ready for Receiving). (Default.)
n = Specifies the method to be used by the modem to control the flow of transmitted data from
the DTE.
0 None.
1 XON/XOFF on received data.
2 CTS/RTS. (Default.)
Reporting Current or Selected Values
Command: +IFC?
Response: +IFC: m,n
Example: +IFC: 2,2 for the defaults.
Reporting Supported Range of Parameter Values
Command: +IFC=?
Response: +IFC: (m range),(n range)
Example: +IFC: (0-2),(0-2)
10.4.19 +ILRR=n - DTE-Modem Local Rate Reporting
This extended-format numeric parameter controls whether or not the extended-format +ILRR:<rate>
information text is transmitted from the modem to the DTE.
Command: +ILRR=n
0 Disables reporting of local port rate (+ILRR: is not transmitted). (Default.)
1 Enables reporting of local port rate (+ILRR: is transmitted).
Reporting Current or Selected Values
Command: +ILRR?
Response: +ILRR: n
Example: +ILRR: 0 For the default setting
Reporting Supported Range of Parameter Values
Command: +ILRR=?
Response: +ILRR: (n range)
Example: +ILRR: (0,1)