Control Microsystems 5901 - VCID=N - Caller ID (CID); AT- Command Set; Kn - MNP 10 Extended Services; Sms=N - Select Mode

5901 High Speed Dialup Modem Hardware Manual
October 19, 2007
61
Result Code:
OK Valid sub parameter string
ERROR Otherwise.
10.4.25 +VCID=n - Caller ID (CID)
This command controls the reporting and presentation of data associated with the Caller ID services
in the Incoming Call Line ID (ICLID) data format.
+VCID=0 Disable Caller ID reporting. (Default).
+VCID=1 Enables Caller ID with formatted presentation to the DTE. The modem will present
the data items in a <Tag><Value> pair format. The expected pairs are date, time, name, and caller
code (telephone number), +VCID=2 Enables Caller ID with unformatted presentation to the DTE.
Reporting Current or Selected Values
Command: +VCID?
Response: +VCID: n
Example: +VCID: 0 For the default setting.
Reporting Supported Range of Parameter Values
Command: +VCID=?
Response: +VCID: (n range)
Example: +VCID: (0-2)
10.5 AT- Command Set
10.5.1 -Kn – MNP 10 Extended Services
Enables or disables conversion of a V.42 LAPM connection to an MNP 10 connection. The
parameter value, if valid, is written to S40 bits 0 and 1.
-K0 Disables V.42 LAPM to MNP 10 conversion. (Default.)
-K1 Enables V.42 LAPM to MNP 10 conversion.
-K2 Enables V.42 LAPM to MNP 10 conversion; inhibits MNP Extended Services initiation
during V.42 LAPM answer mode detection phase.
Result Codes:
OK n = 0 to 2.
ERROR Otherwise.
10.5.2 -SMS=n - Select Mode
Selects Data mode, AudioSpan (analog simultaneous voice and data), or DSVD (digital
simultaneous voice and data) or enables automatic mode selection. The x parameter selects the
mode.