Control Microsystems 5901 - D - Display Delayed Numbers; AT) Command Set; Mn - Enable Cellular Power Level Adjustment

5901 High Speed Dialup Modem Hardware Manual
October 19, 2007
71
Command: *B
Example: NO. - PHONE NUMBER -
------ ------------------------------
1; 4175537660
2; 8288924961
3; 3887278862
4; 3124839442
5; 6284664
OK
10.8.3 *D - Display Delayed Numbers
This command causes the modem to send a list of the delayed numbers together with the delay
associated with each. The modem will return a list of delayed telephone numbers as defined in the
*B command. The format of the response is shown by the example below (delay times are shown as
hours:minutes:seconds). If no numbers are delayed, only the OK result code is issued.
Command: *D
Example: NO. - PHONE NUMBER -DELAY
------ -------------------------- ----------------
1; 8264734660 2:00:00
2; 7532634661 2:00:00
3; 2587334662 0:02:00
4; 7532651663 0:03:25
5; 7459931664 0:01:45
OK
10.9 AT) Command Set
10.9.1 )Mn - Enable Cellular Power Level Adjustment
This command is included for compatibility only and has no effect other than returning a result
code.
Command: )Mn
n Decimal number corresponding to the selected option.
0 )M0 command.
1 )M1 command.
2 )M2 command.
Result Codes:
OK 0 to 2.