Control Microsystems 5901 - Page 6

5901 High Speed Dialup Modem Hardware Manual
October 19, 2007
5
10.4.22 +ITF=a,b,c - Transmit Flow Control Thresholds ................................ 57
10.4.23 +MR=n - Modulation Reporting Control ............................................. 58
10.4.24 +MS - Select Modulation ................................................................... 59
10.4.25 +VCID=n - Caller ID (CID) ................................................................. 61
10.5 AT- Command Set .................................................................................. 61
10.5.1 -Kn – MNP 10 Extended Services ..................................................... 61
10.5.2 -SMS=n - Select Mode ...................................................................... 61
10.5.3 –STE=n - Set Telephony Extension .................................................. 62
10.6 AT\ Command Set .................................................................................. 63
10.6.1 \Bn - Transmit Break to Remote ........................................................ 63
10.6.2 \Kn - Break Control ............................................................................ 63
10.6.3 \Nn - Operating Mode ........................................................................ 64
10.6.4 \Vn - Single Line Connect Message Enable ...................................... 65
10.7 AT% Command Set ................................................................................ 66
10.7.1 %7 - Plug and Play Serial Number .................................................... 66
10.7.2 %8 - Plug and Play Vendor ID and Product Number ......................... 66
10.7.3 %Cn - Enable/Disable Data Compression......................................... 66
10.7.4 %En- Enable/Disable Line Quality Monitor and Auto-Retrain or
Fallback/Fall Forward.............................................................................................. 67
10.7.5 %L - Report Line Signal Level ........................................................... 67
10.7.6 %Q - Report Line Signal Quality........................................................ 68
10.7.7 %Un - Select µ-Law or A-Law Codec Type ....................................... 68
10.8 AT* Command Set .................................................................................. 68
10.8.1 **- Load Flash Memory ...................................................................... 68
10.8.2 *B - Display Blacklisted Numbers ...................................................... 70
10.8.3 *D - Display Delayed Numbers .......................................................... 71
10.9 AT) Command Set .................................................................................. 71
10.9.1 )Mn - Enable Cellular Power Level Adjustment ................................. 71
10.10 At@ Command Set ................................................................................. 72
10.10.1 @Mn - Initial Cellular Power Level Setting ........................................ 72
10.11 AT: Command Set .................................................................................. 72
10.11.1 :En - Compromise Equalizer Enable Command ................................ 72
11 MODEM S-REGISTERS .............................................................................. 73
11.1 S0 - Number of Rings to Auto-Answer .................................................... 73
11.2 S1 - Ring Counter ................................................................................... 73
11.3 S2 - Escape Character ........................................................................... 73