Control Systems 3B6 SLIM - Calibration: Maximum Settings; Setting Maximum Angle and Extended Boom Length

Calibration Max settings
13
Fully extend the boom and set the angle between 65-70 degrees.
Press and release the UP arrow pushbutton until you see the TRANSDUCER 13 Trands.
Max menu.
3B6
Please Confirm
Enter
ACT
a
r
h
l
STOP
Index
+
-
Enter
ACT
a
r
h
l
STOP
Index
+
-
Boom should be fully extended to set the maximum boom length. Press and release the
ENTER pushbutton the display changes to
Enter
ACT
a
r
h
l
STOP
Index
+
-
Now we must save the calibration for the min and max angle and length settings. Angle
should indicate properly and length should indicate 0 percent when fully retracted and
100 percent when fully extended.
TRANSDUCER
13 Transd. Max
TRANSDUCER
Index to Confirm
CONFIGURATION
32 Config.
The display changes back to the first menu CONFIGURATION
32 Config.