Pick and Place Gantry Control
Objective: Utilise standard products with easy
programming for point-to-point position control
Solution: Unidrive with MC204 controller
Operation: MC204 moves all three axes from 3-D position
to 3-D position co-ordinates quickly and
accutately.
Results: Easy system set up with rapid and accurate
positioning.
High Speed Label Printing
Objective: Higher throughout, decreased changeover
time, better accuracy than mechanical system
Solution: Unidrive with UD70 digital lock
Operation:The UD70 performs a complex cam type
profile to insure placing arm and product are
always at the same speed.
UD70 compensates for small product to
product registration shifts by using a product
sensor on the master axis.
Results: Increased accuracy because placement
follows product regardless of conveyor speed.
Constant Web Speed Unwind Control
with Tension Input
Objective: Precise and constant web speed and position
control.
Solution: Unidrive with UD70 winder control.
Operation: UD70 controls the web speed and position
based on encoder signal input. As the
diameter of the take up roll increases, the
Unidrive slows the speed of the Unimotor.
Results: Precise speed regulation and the exact amount
of material is wound onto the take up roll.
typical applications
To Next Page
Loading...
