Need help?Do you have a question about the Control Techniques Midi-Maestro and is the answer not in the manual?
General| Brand | Control Techniques |
|---|---|
| Model | Midi-Maestro |
| Category | DC Drives |
| Language | English |
Describes where to install the drive, considering dust, fumes, and liquids.
Explains when a choke is required and provides dimensions.
Details the requirement for an external braking resistor for Maxi-Maestro.
Discusses maintaining cooling in sealed enclosures and vertical installation.
Lists pin assignments for the power connector and their functions.
Explains how to calculate the required transformer power rating.
Shows DC bus voltage and transformer secondary voltage.
Details fitting fuses in primary and secondary circuits.
Explains connecting signal common and power common to a single ground point.
Shows how to connect the motor to the drive's power connector.
Illustrates connecting braking resistors for Midi-Maestro and Maxi-Maestro.
Lists pin assignments for signal connections and their descriptions.
Describes the five potentiometers on the daughter board for configuration.
Details standard settings and functions of the switches on the daughter board.
Lists and describes resistors and capacitors that may be fitted on the daughter board.
Detailed guide for adjusting Midi-Maestro Drive parameters including speed, current, and torque.
Detailed guide for adjusting Maxi-Maestro Drive parameters including speed, current, and tacho loss.
Verifies component values, cable connections, and polarity.
Step-by-step guide for powering up and testing the drive and motor.
Explains the use of LEDs and digital outputs for monitoring status.
Details the meaning of I2t, Tacho Loss, and Drive Normal LEDs.
Describes the I2t and Drive Normal output signals.
Troubleshooting steps when the green LED is off.
Troubleshooting steps for braking resistor issues.
Troubleshooting steps for motor control problems.
To Next Page