Control Techniques PLC
The Gro
Newtown
Powys
UK
SY16 3BE
Midi Maestro 140 x 8/16
Midi Maestro 140 x 14/28
Maxi Maestro 25/50
The above servo Drive products have been designed
and manufactured in accordance with the following
European harmonised, national and international
standards:
EN60249 Base materials for printed circuits
IEC326-1 Printed boards: General information for the
specification writer
IEC326-5 Printed boards: for single and double sided printed
boards with plated through holes
IEC326-6 Printed boards: Specification for multilayer printed
boards
IEC664-1 Insulation co-ordination for equipment within low-
voltage systems: Principles, requirements and tests
EN60529 Degrees of protection provided by enclosures
(IP code)
UL94 Flammability rating of plastic materials
This product complies with the Low Voltage Directive
73/23/EEC and the CE Marking Directive 93/68/EEC.
W. Drury
Technical Director
Newtown
Date: 7 April 1999
This electronic Drive product is intended to be used
with an appropriate motor, controller, electrical
protection components and other equipment to form
a complete end product or system. It must only be
installed by a professional assembler who is familiar
with requirements for safety and electromagnetic
compatibility (EMC). The assembler is responsible
for ensuring that the end product or system complies
with all the relevant laws in the country where it is to
be used. Refer to the product manual or EMC data
sheet for further information on EMC standards
complied with by the product, and guidelines for
installation.
Declaration of Conformity
To Next Page
Loading...
Need help?
General
