Need help?Do you have a question about the Control Techniques Commander SKB3400150 and is the answer not in the manual?
General| Model | Commander SKB3400150 |
|---|---|
| Type | DC Drive |
| Input Voltage | 380-480 V AC |
| Output Current | 150 A |
| Enclosure Type | IP20 |
| Amperage | 150 A |
| Voltage | 480 V |
| Communication Interface | RS485 |
| Input Voltage (DC) | Not applicable |
| Control Mode | Speed Control / Torque Control |
| Protection Features | Overcurrent, Overvoltage, Overtemperature |
Explains Warning, Caution, and Note symbols, electrical hazards, and system design safety.
Precautions for electrical installation, including shock risk, isolation, and stored charge.
Diagrams showing power terminal connections for different drive sizes.
Requirement for suitable protection against overload and short circuits.
Step-by-step procedure for navigating and modifying drive parameters via the keypad.
How to set, unlock, re-lock, and remove security codes for parameter access.
Overview of Level 1 parameters including set speeds and ramp rates.
Setting up drive configuration for various input modes like AI.AV and AV.Pr.
Setting motor parameters like current, speed, voltage, and power factor.
Configuring analog output, switching frequency, and initiating autotune.
Setting brake release/apply thresholds, frequencies, and delay times.
Diagram showing minimum required control terminal connections for terminal control.
Diagram showing minimum required terminal connections for keypad control.
Pre-power up checks, drive power up, parameter entry, and autotune.
Procedure for autotune, running the drive, and adjusting speed.
Table listing trip codes, conditions, and possible causes for drive faults.
Comprehensive list of parameters with default values for EUR and USA.
To Next Page