Control Techniques Unidrive LV Series User Manual

Unidrive LV model sizes 1 to 3 Installation Guide
Issue code: uliu1
ii
Control Techniques plc
The Gro
Newtown
Powys
UK
SY16 3BE
UNI1201 UNI1202 UNI1203 UNI1204 UNI1205
UNI2201 UNI2202 UNI2203
UNI3201 UNI3202 UNI3203 UNI3204
The AC variable speed drive products listed above,
including the VTC and LFT variants, have been
designed and manufactured in accordance with the
following European harmonised, national and
international standards:
EN60249 Base materials for printed circuits
IEC326-1 Printed boards: general information for the
specification writer
IEC326-5 Printed boards: specification for single- and
double-sided printed boards with
plated-through holes
IEC326-6 Printed boards: specification for multilayer
printed boards
IEC664-1 Insulation co-ordination for equipment
within low-voltage systems: principles,
requirements and tests
EN60529 Degrees of protection provided by
enclosures (IP code)
UL94 Flammability rating of plastic materials
UL508C Standard for power conversion equipment
EN50081-1
1
Generic emission standard for the
residential, commercial and light industrial
environment
EN50081-2 Generic emission standard for the industrial
environment
EN50082-2 Generic immunity standard for the
industrial environment
EN61800-3 Adjustable speed electrical power drive
systems – Part 3: EMC product standard
including specific test methods
1
Conducted emission. See the relevant EMC Data
Sheet.
These products comply with the Low Voltage
Directive 73/23/EEC, the Electromagnetic
Compatibility (EMC) Directive 89/336/EEC and the
CE Marking Directive 93/68/EEC.
W. Drury
Executive Vice President, Technology
Newtown
Date: 20th September 1999
These electronic Drive products are
intended to be used with appropriate
motors, controllers, electrical
protection components and other
equipment to form complete end
products or systems. Compliance with
safety and EMC regulations depends
upon installing and configuring Drives
correctly, including using the specified
input filters. The Drives must be
installed only by professional
assemblers who are familiar with
requirements for safety and EMC. The
assembler is responsible for ensuring
that the end product or system
complies with all the relevant laws in
the country where it is to be used.
Refer to the Installation Guide. A
Unidrive EMC Data Sheet is also available
giving detailed EMC information.
Declaration of Conformity

Control Techniques Unidrive LV Series Specifications

General

Brand	Control Techniques
Model	Unidrive LV Series
Category	DC Drives
Language	English