ControlByWeb WEBRelay-10+ - Page 29

Xytronix Research & Design, Inc. Page 29
WebRelay-10 Plus™ Users Manual
This le is read by requesting the syslog.txt le. For example, using the default IP address the following
command would be used:
http://192.168.1.2/syslog.txt
Note: The setup user name and password are required to access this le.
If the TCP port has been changed (not port 80), the port will be required to read the le. For example,
using the default IP address, and port 8000, the log le would be read as follows:
http://192.168.1.2:8000/syslog.txt
To erase the le, use:
http://192.168.1.2/syslog.txt?erase=1