ControlByWeb WebRelay X-WR-1R12-1I5-5

To Next Page

To Previous Page

Appendix C: Accessing the WebRelay Over the Internet WebRelay Users Manual

Note: This screen shot is simply an example of a typical router setup page. Routers will vary.

Accessing Setup Pages

After changing ports, the setup pages are accessed on a local network as described below:

http://(Local IP Address):(Port Number)/setup.html

For example, to access the setup pages of the WebRelay when the port is set to 8001, the following

command would be used:

http://192.168.1.26:8001/setup.html

To access the ControlByWeb units from the Internet, enter the public IP address of the router plus the

port number of the desired device in the following format:

http://(Public IP Address of Router):(Port Number of Device)/setup.html

Using the example above, the following line would be used to access the setup page of the WebRelay:

http://266.70.164.97:8001/setup.html

Page 74 Xytronix Research & Design, Inc.

Example of Port Range Forwarding

ControlByWeb WebRelay X-WR-1R12-1I5-5 - Accessing Setup Pages