CONTROLS, INCORPORATED
CONTROL SYSTEMS & SOLUTIONS
- 1 -
Basic Controller Operation
A. Manual Engine Start / Stop
1. For manual start, put key switch in “Run” position and press “Enter” button to crank
engine. When engine is started manually, the controller will operate. To stop the engine,
the key needs to be switched to the “Off” position.
B. Automatic Engine Start / Stop
1. For auto start, place key in the “Auto” position. When the single or dual float circuit is
closed closed, the controller will begin the engine start sequence. When the single or dual
float circuit is opened, the controller will shut the engine off.
To Next Page
Loading...
