Controls J1939 - ADVANCED OPERATIONAL SETTINGS

24
(10)
Auto Shutdown Configuration
Default Delay Hr:Min
Cooldown Speed
Cooldown Time
(11)
Maintenance Configuration
Service Messages (Default = No)
Reset Interval Yes/No
Service Warning at: (Default = 0 Hrs.)
Service Requires At: (Default = 0 Hrs.)
Next Service Warning Interval (Default = 200 Hrs.)
Next Service Required Interval (Default = 250 Hrs.)
1
st
Service Warning Interval (Default = 75 Hrs.)
1
st
Service Required Interval (Default = 100 Hrs.)
(12)
Emissions Configuration
DEF Level Check
Low DEF Pre Alarm
Low DEF Alarm
DEF Alarm Delay
Allow Service Regen Yes/No (Deere Only)
Regen Interlock On/Off
TSC Transmit Yes/No (stop TSC to engine during regen)
DPF Inhibit Lamp Source
(13)
MODBUS Configuration
MODBUS Mode (Default = Off)
Baud Rate (9600, 19200, 38400)
Parity (None, Even, Odd)
Stop Bits (1, 2)
Slave Address (1 – 247)
Communication Timeout (Default = 0:00)