BLADE ASSEMBLY
Blade
See p� 14
15
Removing the blade assembly
Attaching the blade assembly
Turn the bowl upside down
and use the cap as indicated
in image above� Ensure you
place a soft protection on
your worktop as once the
blade is loose it will fall out
of the bowl�
Whenever you use the metal bowl, always check that the seal is properly fitted and
the screw has been tightened.
Danger of burns from hot food splashes:
Always insert the cap in the lid (unless stated otherwise in the recipe), especially
when you are blending hot ingredients above Speed 7.
If you are making soup and need to add ingredients via the lid opening:
Always press STOP, then add the ingredients, put the cap back, and press AUTO to
resume the programme.
Always hold the cap by the central plastic part.
Never fill the bowl above the max. mark:
0.5 l for steaming, 2.5 l for other preparations.
Never exceed the maximum amounts (p.13).
Put the seal back on the blade�
The seal has two straight sides
to help you position it correctly�
Turn the cap in a clockwise
direction to release the blade�
Slot the base of the blade
assembly into the hole at the
bottom of the bowl� Turn the
bowl upside down, ensuring
you are securely and safely
hold the blade in place�
Holding the universal blade
assembly by the top, remove
the seal for cleaning�
Position the screw on the
underside of the bowl and
tighten with the cap by
turning in an anti-clockwise
direction�
To Next Page