CookTek ISW061 - General Operation; To Rethermalize Soup

Manual ISW06x 14161_A USINTL
4
Plug the soup well into a grounded, single-phase receptacle. Models will run on
either100-125VACor200-240VACdrawingupto900W.Checktheratingplateon
theunittoverifycorrectvoltageandwattage.Voltagesbelowrangecanresultin
lessthanratedpowerandslowerheatingtimes.Thisapplianceisdesignedfor
rethermalizingandholdingsouponly,usingabainmarie.Thesouppanshould
notbeplaceddirectlyintothesoupwell.
Note: For proper operation, an independent, dedicated circuit should be used
for up to 3 units installed on a 15amp (120VAC) circuit, or 4 units installed on
a 20amp (120VAC) circuit.
Tooperateallmodels:
• PressthePowerbuttontoturntheuniton.ThegreenLEDnexttothepowerbutton
willilluminate.PressthePowerbuttonwhenyouarenishedtoturntheunitoff.
• Tolockthecontrols,presstheLockbuttonthreetimes.TheredLEDtotheright
of the lock button will illuminate to indicate the unit is locked. Locking the unit will
preventtemperaturesettingsfrombeingchanged.ThePowerbuttonwillcontinue
tofunctionwhiletheunitislocked.Tounlockthecontrols,pressthelockbutton
three more times. Unplugging the unit when powered on will also unlock the unit.
• PresstheUpandDownArrowstoselectthedesiredtemperature.
Thedefaultpresetchoicesare:
• FahrenheitSettings:170,180,190,200,HEAT
• CelsiusSettings:70,75,80,85,HEAT
Additionaltemperaturesettingsareavailablebychangingthetemperaturesettings
option.See“ChangingtheTemperatureSettings”onpage5.
Note: When the unit is not in use for 5 minutes, it will enter a power save mode
where the Power LED will ash. Press any button on the controls to exit the
power save and return to the previous settings.
Torethermalizesoup:
• Place an 11qt (10.4 L) soup tureen water pan into the soup well. Note: If using a
7qt (6.6 L) soup tureen, an adapter ring is needed to ensure proper heating and
prevent damage to the appliance. Adapter rings must be purchased as an
accessory through CookTek.
• Fill the water pan with the appropriate amount of water.
• Placethesouptureenintothewaterbathandllwithsoup.
• UsetheUpandDownarrowstochangethetemperaturesettingtoHEAT.Note:
rethermalization is only possible when the display shows “HEAT.” Other
temperaturemodeswillonlyholdsouptemperature.
• Thedisplaywillashtheword“HEAT”whenitisinheatingmodeandapanis
detectedontheunit.Ifthedisplaydoesnotash,checkthatthepanisproperly
seated in the unit.
• Maintain the proper amount of water while the unit is operating in heating mode. In
theeventthatallwaterhasevaporated,theunitisequippedwithautomaticboildry
detection.Ifadrypanisdetected,theunitwillstopheatingandash“h2O”onthe
display.Theunitwillnotresumeheatinguntilasufcientamountofwaterhasbeen
added and the insert pan has cooled to a safe temperature.
• Whenthesouphasreachedtemperature,usetheUpandDownarrowstochange
the soup well setting to the desired holding temperature.
GENERAL OPERATION