EasyManua.ls Logo

coolbreeze CB4900 - User Manual

coolbreeze CB4900
16 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
CB4900 / CB6600 Spot Cooler
USER’S MANUAL

Table of Contents

Questions and Answers

  • P
    paul16Aug 11, 2025
    How to fix a coolbreeze Accessories unit that is not working?
    • B
      Brian JohnsonAug 12, 2025
      If your coolbreeze Accessories unit is not working, ensure the power plug is correctly connected. If it is not, connect it properly. Also, verify that the POWER button is set to “ON”. If it's “OFF”, press the POWER button to turn it “ON”. Check the fuse in the mains plug; if it's blown, replace it with a 13amp fuse. Examine the fuse in the board and exchange it if it has blown. Check if the breaker on the switchboard has tripped; if so, assess the load capacity and reset it. Finally, make sure the ambient temperature is not too high; use the unit only below 45°C (or 40°C for HSC-3500 models).
  • T
    Timothy HaysAug 17, 2025
    Why is my coolbreeze Accessories unit not cooling properly?
    • W
      whitekristinAug 17, 2025
      If your coolbreeze Accessories unit isn't cooling effectively, start by checking the filter for dust blockage and clean it if necessary. Next, inspect the heat exchanger for dust and clean it as well. Ensure there are no obstacles blocking the inlet side, and provide at least 50cm of clearance. Also, make sure the ambient temperature is not too high; the unit should be used below 45°C (or 40°C for HSC-3500 models).
  • C
    christensenandrewAug 22, 2025
    What to do if my coolbreeze CB4900 shows E1 (High Pressure) error?
    • K
      Kimberly FloresAug 23, 2025
      If your coolbreeze Accessories unit displays an E1 error (High Pressure), the motor outdoor might not be operating. Check the power supply to the motor. Also ensure that hot air from the chamber is being blown out completely. Improve conditions to ensure proper hot air expulsion.
  • A
    Alyssa BrownAug 29, 2025
    What does AF mean on my coolbreeze CB4900?
    • X
      xsellersAug 29, 2025
      If your coolbreeze Accessories unit displays an AF error (Anti Freezing), it indicates that the evaporator is frozen, likely because the ambient temperature is below 20°C. To resolve this, operate the unit continuously until the “AF” error disappears, or switch to “FAN” mode.
  • E
    eblackburnSep 4, 2025
    What does E3 error mean on coolbreeze CB4900 Accessories?
    • M
      michaelrossSep 4, 2025
      If your coolbreeze Accessories unit displays an E3 error (Sensor Problem), it means the thermistor sensor wire is cut. To fix this, you need to change the thermistor sensor.

coolbreeze CB4900 Specifications

General IconGeneral
Brandcoolbreeze
ModelCB4900
CategoryAccessories
LanguageEnglish