Revised: 15/02/16 31/03/2016
2
WARNING
THE FOLLOWING INSTRUCTIONS MUST BE CARRIED OUT OR
WARRANTY BECOMES VOID.
Heater must be installed by a Coonara authorised technician. List is available
on www.shamicheating.com. You must obtain a license number from the
installer.
Inbuilt and Freestanding Heaters must be placed on a flat level surface.
Inbuilt models must be placed on 6mm AC sheeting, to prevent unit from
rattling.
Heater must be checked for scratches or dents prior to installation.
All glass must be fitted with a screw driver not a drill. If glass is broken upon
installation due to the screws being tightened too much, it will not be classed
under warranty.
Further safety precautions and installation instructions are contained
throughout this manual. Please read the manual before installation.
To Next Page
Loading...
