Revised: 15/02/16 31/03/2016
8
WARNING
Heater must be checked for scratches or dents prior to installation.
Once the Heater is installed scratches or dents are NOT covered by warranty.
Heater must be placed on a flat level surface.
Inbuilt models must be placed on AC sheeting, to prevent unit from rattling.
INSTALLATION OPTIONS:
* ONLY TO BE CARRIED OUT BY A COONARA AUTHORISED TECHNICIAN!
The Clear View and Barossa Inbuilt Heaters are a zero clearance appliance and can
be optionally installed in a false fireplace or wall cavity made of combustible
materials such as wood or chipboard. Coonara provide the heater with their own
flue kit, of flexible pipes of 60mm and 50mm diameter for the inlet and exhaust. For
the gas supply a flexible hose is provided and must be used.
SERVICE INSTRUCTIONS
1. To access flue fan on the Barossa the heater needs to be removed
2. To access the flue fan on the Clearview only the rear fascia needs to be removed
3. To access all other componentry on the Barossa & Clearview the front fascia needs to be
removed
4. To access the fire box read Installation Instructions page 10
To Next Page
Loading...
