Revised: 15/02/16 31/03/2016
5
SAFETY PRECAUTIONS
SAFETY GUARD
INSTALLATION
Instructions for operation with THERMOSTAT
!
DO NOT OPERATE THIS APPLIANCE BEFORE READING THIS
INSTRUCTION MANUAL.
DO NOT PLACE ARTICLES ON OR AGAINST THIS APPLIANCE.
DO NOT USE OR STORE CHEMICALS/FLAMMABLE MATERIALS OR
SPRAY AEROSOLS NEAR THIS APPLIANCE
DO NOT OPERATE WITH PANELS, COVERS OR GUARDS REMOVED
FROM THIS APPLIANCE.
DO NOT ENCLOSE THIS APPLIANCE
DO NOT MODIFY THIS APPLIANCE.
ALWAYS SUPERVISE YOUNG CHILDREN NEAR THE APPLIANCE
NOTE: In the event the electricity supply cord is damaged, it must be replaced with an
original Coonara part obtainable from your authorized dealer.
THE SAFETY GUARD AROUND THE GLASS DOOR IS FITTED TO THIS
APPLIANCE TO REDUCE THE RISK OF FIRE OR INJURY FROM BURNS. NO
PART OF IT SHOULD BE PERMANENTLY REMOVED.
IF HEATER IS
DAMAGED
, DURING REMOVAL OF SAFETY GUARD, DAMAGE WILL NOT
BE COVERED BY WARRANTY.
IT IS RECOMMENDED THAT A SECONDARY GUARD BE USED TO PREVENT
ACCESS TO THE APPLIANCE BY YOUNG CHILDREN AS OUTER PANELS
MAY REACH HIGH TEMPERATURES.
THIS APPLIANCE SHALL ONLY BE INSTALLED BY A COONARA
AUTHORISED TECHNICIAN IN ACCORDANCE WITH:
- AS/NZ S 5601.1 (GAS INSTALLATION CODE)
- MANUFACTURERS INSTALLATION INSTRUCTION
- LOCAL GAS FITTING REGULATIONS, AND
- MUNICIPAL BUILDING CODES.
To Next Page
Loading...
