ALARM - YES
DETECTOR - NO
ALARM - YES
DETECTOR - YES
ALARM - NO
DETECTOR - YES
Or
‘No alarms found.’
If the message is ‘No alarms found.’ is displayed, it can be cleared by adding a suitable initiation
device, such as a fire alarm signal and/or local heat or smoke detector.
4) The MK5 display will now prompt you to set the correct motor type, by default this will be set to the
10Nm (White) motor type. This can be changed to the 30Nm (Red) motor type if needed.
The MK5 display now changes to:
‘IN MANUAL MODE.
AUTO press OK.’
DO NOT PRESS THE ‘OK’ BUTTON UNTIL INSTRUCTED BELOW AS THIS WILL EXIT THE
‘MANUAL MODE’.
While this mode is active the curtain can be raised and lowered using the up and down
pushbuttons. When you have finished operating the curtain in manual mode please return the
curtain to the fully descended position.
Press the OK button and the unit will enter AUTO mode and the display will change to read ‘IN
AUTO MODE.’ and display the date and time.
If all the Alarm / Detector(s) are OK, the curtain will retract.
It is important that the settings are done in sequence as some settings are affected by
others.
5) Accessing the Menu
To enter the menu, press and hold the OK button until the display changes to ‘Enter Code’.
The code for this unit is: 8421
To enter the code, use the ↑ and ↓ to set each digit before using the ← and → buttons to change
digit. Once the correct number is displayed, press the OK button to enter the menu.
7.2 Critical Settings
6) Setting the Clock
Use the ↑ and ↓ buttons to navigate the menu and select ‘Set Clock.’ by pressing the OK button.
First set the year. Use the ↑ and ↓ buttons to select the correct year and press the OK button.
To Next Page
Loading...
Need help?
General