Copower SANDOLAB TP - Page 11

11
Start editing the dyeing program:
Step 1: Target Temperature=60℃, Gradient = 3℃/min, Holding Time = 0min
a. Click the Target Temp. column of Step 1, input 60, then click Enter to
confirm inputted data.
b. Click the Gradient column of Step 1, input 3.0, then click Enter to confirm
inputted data.
Step 2: Target Temperature =100℃, Gradient = 2℃/min, Holding Time =
30min, Dose Alarm = 10 min
a. Click the Target Temp. column of Step 2, input 100, then click Enter to
confirm inputted data.
b. Click the Gradient column of Step 2, input 2.0, then click Enter to confirm
inputted data.
c. Click the Holding Time column of Step 2, input 30, then click Enter to
confirm inputted data.
Input dyeing program Name
Program details
Clear all from screen
Click NEXT for next page. (5
steps can be edited in a page,
total to 4 pages)
Input data within this
range.
Click Enter to confirm
inputted data.
Step sequence