2FT-3.0
1-4-2
(2) Maintenance modes item list
Section Item
No.
Content of maintenance item Initial
setting*
General U000 Outputting an own-status report -
U001 Exiting the maintenance mode -
U002 Setting the factory default data -
U003 Setting the service telephone number ***************
U004 Displaying the machine number -
U005 Copying without paper -
U019 Displaying the ROM version -
Initialization U020 Initializing all data -
U021 Initializing memories -
U022 Initializing backup memory -
U026 Evacuation of backup data -
U027 Return of backup data -
Drive, paper
feed, paper
conveying
and cooling
system
U030 Checking motor operation -
U031 Checking switches for paper conveying -
U032 Checking clutch operation
U034 Adjusting the print start timing
Adjusting the leading edge registration
Adjusting the center line
Adjusting the trailing edge margin
4.0/3.6/3.6/3.6/3.6/4.5
-1.0/0.4/-1.2/-1.2/-1.2/0.3
-2.0
U035 Setting folio size
Length
Width
330
210
U051 Adjusting the amount of slack in the paper -10/-15/15/-20/-20/-5
U053 Performing fine adjustment of the motor speed -0.3/0/-0.6/0.5/-0.1/-0.1/
-0.2/-1.3/-1.5/0.6
U055 Setting the motor periodic drive 1/30
U059 Setting the fan mode 5
Optical U060 Adjusting the scanner input properties 12
U061 Turning the exposure lamp on -
U063 Adjusting the shading position 0
U065 Adjusting the scanner magnification
Main scanning direction/auxiliary scanning direction 0/-12
U066 Adjusting the leading edge registration for scanning an
original on the contact glass
10/0
U067 Adjusting the center line for scanning an original on
the contact glass
-4/0
U068 Adjusting the scanning position for originals from the DP 0
U070 Adjusting the DP magnification 0/0
U071 Adjusting the DP scanning timing 0/0/0/0
U072 Adjusting the DP center line 0/0/0
U073 Checking scanner operation -
U074 Adjusting the DP input light luminosity 0
U076 Executing DP automatic adjustment -
U087 Turning the DP scanning position adjust mode on/off ON/35
U089 Outputting a MIP-PG pattern -
U092 Adjusting the scanner automatically -
*Initial setting for executing maintenance item U020
To Next Page
Loading...
