What to do if there is no spark when lighting the gas on my CORBERO Hob?
If there is no spark when lighting the gas on your CORBERO Hob, first, ensure that the unit is properly plugged in and the electrical supply is switched on. Then, check if the mains fuse has blown. Finally, confirm that the burner cap and crown have been correctly replaced, for example, after cleaning.
Why does the gas ring burn unevenly on my CORBERO CPCG601X?
If your CORBERO Hob gas ring burns unevenly, ensure that the main jet is not blocked and the burner crown is clear of any food particles. Also, verify that the burner cap and crown have been correctly replaced, especially after cleaning.
Procedure for lighting gas burners using a match or lighter, including safety precautions.
Instructions for cleaning the hob surface, including recommended and prohibited cleaning agents.
Guidance on cleaning pan supports and removing stubborn stains.
Steps for cleaning removable burner caps and crowns using soapy water.
Importance of keeping the thermocouple clean for gas supply safety.
Minimum room volume and air vent requirements for safe gas hob installation.
Suitable locations for hob installation and minimum clearance distances from walls and cabinets.
Steps to take after installation, including removing protective materials and ensuring accessibility.
Details on connecting the gas supply using rigid or semi-rigid pipes and leak testing.
Specifications for the required cut-out dimensions in the worktop for fitting the hob.
Procedure for installing the hob into the worktop using seals and fixing clamps.
Steps to check the minimum flame setting and burner stability after installation.
Note that conversion must be done by a competent person and requires correct injectors.
Steps for conversion, including gas tap settings, power isolation, and component removal.
Procedure for adjusting the gas rate using the pass adjustment screw after conversion.
To Next Page
General