EasyManuals Logo

Core CGT 400 User Manual

Core CGT 400
68 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #27 background imageLoading...
Page #27 background image
20
Chargeur standard CRC-6500-S – suite
NOTA :
a) Contrairement aux piles
traditionnelles, les piles au lithium-ion
perdent très peu d’énergie et
conservent presque toute leur pleine
puissance. Lorsque la pile est
complètement déchargée, le circuit
électronique de commande de la pile
coupe immédiatement la puissance de
sortie vers l’outil, sans avertissement.
Une pile déchargée doit être rechargée
dès que possible afin de conserver son
potentiel de tension de fonctionnement
et pour la prochaine utilisation.
b) Ne chargez PAS la pile lorsque l’aire
de travail ou la température de la pile
est égale ou inférieure à 32 °F (0 °C),
ou supérieure à 113 °F (45 °C). La
température optimale est de 68 °F
(20 °C).
c) Une fois que la pile est chargée à
bloc, retirez-la du chargeur et
débranchez le chargeur.
ASSEMBLAGE ET FONCTIONNEMENT
27
INSTALLING THE POWER CELL
Once the Power Cell has been fully
charged and you are ready to start
trimming, you will have to install the
Power Cell into the trimmer.
1. Position the Power Cell (1) with the
"TOP" label (2) facing upward
(Fig. 11).
2. Slide the Power Cell into the
matching cavity (3) in the rear of
the upper cowling (4).
NOTE: Make sure you push the
Power Cell fully into the cavity. The
locking latch (5) will click when the
Power Cell is properly installed.
3. Pull outward on the Power Cell to
verify that it is being held in place
by the locking latch.
To remove the Power Cell for
recharging or storage, press the locking
latch toward the Power Cell. While
holding the locking latch toward the
Power Cell, pull the Power Cell out of
the tool.
OPERATING POSITION
WARNING
: Never operate the
trimmer with one hand. Always hold the
trimmer with one hand on the forward
handle and the other hand on the rear
handle to operate the switches. Operate
the trimmer below waist height at all
times. Always wear appropriate
personal protective equipment. Never
operate the trimmer on its edge while
trimming grass. The trimming line
should always be near and parallel to
the ground to avoid scalping and
throwing debris.
ASSEMBLY AND OPERATING
Fig. 11
!

Table of Contents

Other manuals for Core CGT 400

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Core CGT 400 and is the answer not in the manual?

Core CGT 400 Specifications

General IconGeneral
BrandCore
ModelCGT 400
CategoryTrimmer
LanguageEnglish

Related product manuals