4
BODY PROTECTION
ELECTRICAL SAFETY
PRODUCT SAFETY NOTICES – OWNER’S REGISTRATION
GENERAL SAFETY WARNINGS
WARNING: To avoid electrical hazards, fire hazards or damage
to the tool, use proper circuit protection.
The charger for this tool is wired at the factory for 120 V operation. It
must be connected to a 120 V, 15 A circuit that is protected by a time-
delayed fuse or circuit breaker. To avoid shock or fire, replace the
power cord immediately if it is worn, cut or damaged in any way.
WARNING: Always wear non-slip gloves that fit properly to
protect your hands and to help you grip the tool.
WARNING: Always wear sturdy clothing with long sleeves and
long pants. Never operate the tool while wearing shorts, short
sleeve shirt or while shirtless.
WARNING: Always wear non-slip safety boots to prevent foot
injuries and slipping that could cause loss of control of the tool.
SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE
NOTICE: To permit the receiving of product safety notices from CORE™
Outdoor Power for potential future safety guidance communications and /
or safety product recall notices, please register your GasLess™ Trimmer
tool, Power Cells and Power Cell chargers online at
WWW.COREOUTDOORPOWER.COM. Note: The registration of product
model number and serial number is for safety communications purposes
only and not for warranty registration purposes.
To Next Page
Loading...
