Corken F1521 User Manual

Installation, Operation
& Maintenance Manual
Sliding-Vane Stationary Pumps for LPG and NH
3
All Models 51, 521, and 1021
Solutions beyond products...
ORIGINAL INSTRUCTIONS IC101H
D51 Model
1021 Model
Warning: (1) Periodic inspection and maintenance of Corken products is essential. (2) Inspection, maintenance and installation of Corken
products must be made only by experienced, trained and qualified personnel. (3) Maintenance, use and installation of Corken products
must comply with Corken instructions, applicable laws and safety standards (such as NFPA Pamphlet 58 for LP-Gas and ANSI K61.1-1972
for Anhydrous Ammonia). (4) Transfer of toxic, dangerous, flammable or explosive substances using Corken products is at user’s risk and
equipment should be operated only by qualified personnel according to applicable laws and safety standards.

Corken F1521 Specifications

General

Brand	Corken
Model	F1521
Category	Water Pump
Language	English

Summary

Chapter 1: Installation Procedures

1.1 Location

Details pump placement, foundation, and tank requirements for optimal performance.

1.2 Inlet Piping Requirements

Specifies essential components and configurations for pump inlet piping.

1.3 Outlet Piping Requirements

Outlines necessary components for safe and efficient pump outlet piping.

1.4 Bypass System Requirements

Details the necessity and components of a pump bypass system for safety.

1.5 Vapor Equalizing System

Explains the function and benefits of a vapor equalizing system for pump performance.

1.6 Driver Installation

Covers the critical aspects of installing the pump's driver (motor or engine).

Chapter 2: Operation Procedures

Chapter 3: Maintenance Procedures

3.1 Preventative Maintenance Procedures

Outlines routine checks and tasks to ensure pump longevity and safety.

Chapter 4: Seal Replacement Instructions

4.1 Repair Kits and Spare Parts

Appendix G: Troubleshooting Guide

Troubleshooting Guide

Lists common pump problems, their causes, and recommended solutions.