1.1.1 Arm lock (“ML)
The device is used to lock the arm in a raised position, preventing accidental descent. Follow the user
instructions:
• turn off the engine;
• remove the device from its housing in a horizontal position on the side of the ML
kit by unscrewing the handwheel;
• Insert the slots of the bar near the piston of the hydraulic jack;
• Rotate the bar and position it parallel to the piston;
• slowly lower the unit with the engine off until the device engages.
DANGER: if interventions or maintenance operations are to be carried out with the arm
raised, always operate with the engine off and the unit locked with the dedicated bar.
At the end of the procedure, remove the device and place it back in its housing.
1.6 ACCESSORIES
READ CAREFULLY: Read the instructions and the mode of use for the
accesso- ries that have been installed on your machine carefully. Refer to the
instruction manual that was provided with them.
The machine is furnished with equipment to make it possible to carry out normal
maintenance operations. It is also equipped with a hydraulic force instrument: in the
manual the instructions for its use have been furnished. Also, the machine the may
also be equipped upon request with particular tools including:
•
Cement mixer for mixing concrete;
•
Auto-loading tools;
•
Excavator;
•
Demolition hammer.
To Next Page
Loading...
