EasyManua.ls Logo

cormidi C85 Series - Machine Storage Procedures; Maintenance Introduction

cormidi C85 Series
60 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Maintenance
46
3.12 STORAGE
Whenever the machine must remain inactive for several months, it is necessary to
provide a correct garaging so that the machine is in perfect working order when it is
used again. In particular one must carry out storage by following all of these in-
structions:
Carry out all necessary repairs;
Disconnect the battery, turning the device to cut off battery;
Empty the fuel tank completely;
Proceed with a careful cleaning and remove all mud, and/or organic
residues carefully;
Proceed with all operations regarding the motor that are described in its
own manual;
Carry out a greasing of all points listed in the specific chapter;
Place the machine in such a way that it is sheltered from atmospheric
agents under stable conditions and on a flat surface;
If the machine is equipped with batteries, unplug them and lubricate with
the correct grease;
Periodically, every two months, recharge the battery;
Take it out and conserve in a safe place
When putting the machine back into service:
carry out all greasing again in all prescribed points found in the specific
chap- ter;
If the machine is equipped with a battery, recharge it and reconnect it being
certain of the correct polarity of the ends;
Insert the cut off battery lever;
Proceed with the operat. concerning the motor described in its own manu-
al;
Check the oil level and add some if necessary.
1 MAINTENANCE
DANGER: always carry out all maintenance operations with the motor off
and with the start up keys not inserted.
DANGER: During Maintenance, the dumper body should be empty,use the
safety support, and discharge the HYD System from any pressure
insidethe system.
Good maintenance is required and is the secret to low operating costs andextend
the life of your machine, keeping it up and running.
In addition to regular maintenance on mechanical and plumbing, it is good prac- tice
to periodically clean the machine and carry out a thorough cleaning to re- move all
traces of mud. After each wash is necessary to grease all parts subject to friction, as

Related product manuals