• Once removed and reloaded, it can be inserted. The procedure is as follows:
Insertion the battery pack
• Bring the original Cormidi trolley near the hood of the C85 with the charged
battery ready for use on it;
• Open the front rods as shown in figure “2”;
• Open the hood of the machine and hook the two rods just opened to the hood
base, on the sheet metal bumper;
• Slowly pull the battery pack, making it slide on the two rods until it reaches its
housing inside the hood of the C85;
• Fix the battery so that it does not move, with the pins provided and hook the
connector as in figure "4
3.4.2 Charging using the cable without moving
the battery pack.
The C85 is equipped with a “Standard” type battery charger supplied, with which it
is possible to restore the battery to 100% of its charge whenever necessary. The
Standard type it can be connected to 220 Volt current.It is also possible to halve the
recharging times by purchasing, on request, the “Supercharged” battery charger
which can only be connected to the 380 Volt electrical network.
To Next Page
Loading...
