Cornelius 200 User Manual

Service Manual
SELF-CONTAINED FLAKED ICE MAKER
Model: Series 200, 525, 725
(R404A Refrigerant)
IMPORTANT:
TO THE INSTALLER.
It is the responsibility of
the Installer to ensure that
the water supply to the
dispensing equipment is
provided with protection
against backflow by an air
gap as defined in
ANSI/ASME A112.1.2-1979;
or an approved vacuum
breaker or other such
method as proved effective
by test.
Water pipe connections
and fixtures directly
connected to a potable
water supply shall be
sized, installed, and
maintained according to
Federal, State, and Local
Codes.
PRINTED IN U.S.A
IMI CORNELIUS INC; 1993--96Ó
IMI CORNELIUS INC g One Cornelius Place g Anoka, MN 55303-6234
Telephone (800) 238-3600 Facsimile (612) 422-3246
Part No. 166240010
November, 1993
Revised: October, 1996
THIS DOCUMENT CONTAINS IMPORTANT INFORMATION
This Manual must be read and understood before installing or operating this equipment

Cornelius 200 Specifications

General

Production Rate	Up to 200 lbs per day
Type of Ice	Cube
Cooling System	Air-cooled
Power Requirements	115V
Weight	150 lbs

Summary

SPECIFICATIONS 200

SPECIFICATIONS 525

SPECIFICATIONS 725

INSTALLATION INSTRUCTIONS

ADJUSTMENT PROCEDURE

ELECTRICAL CIRCUIT

MAINTENANCE

SERVICE ANALYSIS

UNIT WILL NOT RUN

Lists common causes and remedies for the ice maker failing to start or operate.

COMPRESSOR CYCLES INTERMITTENTLY

Addresses issues where the compressor cycles on and off repeatedly during operation.

MAKING WET ICE

Explains potential causes and solutions for the ice maker producing wet or soft ice.

UNIT RUNS BUT MAKES NO ICE

Details problems encountered when the unit operates but does not produce ice.

WATER LEAKS

Covers common sources of water leaks within the ice maker and their respective fixes.

EXCESSIVE NOISE OR CHATTERING

Provides troubleshooting steps for unusual noises or vibrations during operation.

MACHINE RUNS WITH FULL BIN OF ICE

Addresses the issue of the machine continuing to run despite the ice bin being full.

UNIT OFF ON RESET

UNIT GOES OFF ON RESET