Cornelius ABS 2.0 - Page 2

Clean and sanitize conveyor assembly, drip tray and nozzle parts (continued)
©McDonald’s Corporation · Planned Maintenance Manual Page 2 of 4
Cornelius ABS 2.0
DAILY
BE 94
D
1
8
Clean the Drip Tray.
Make sure the water
deflector is properly
installed; this will help
prevent motor
failures. (Order
replacement if the
deflector is missing).
9
Check and flush the
drain.
Pour warm water
down the drip-tray
drain. Flush the drip-
tray using carbonated
water.
10
Wash the drip-tray
area, splash panel
and clean any spills
from the machine
exterior using McD
HA detergent with a
clean cloth.
11
Clean the splash
panels.
Wipe down drip-tray
and splash panel with
a clean cloth to
remove any soapy
residue.
12
Wipe down drip-tray
and splash panel with
a clean cloth to
remove any soapy
residue.
Spray McD sanitizer
all around drip-tray
and splash panel. Let
air dry for 5 minutes.
13
Back Room
Cleaning.
Collect grill,
conveyor, and all
nozzle components
and bring to back
room.
14
Nozzle Cleaning.
Remove the gasket
from the diffuser.
15
Prepare a bucket of
McD HA Detergent
solution.
16
Cleaning the Nozzle
Parts.
Place outer nozzle
housing, diffuser, and
gasket in the soap
solution.
Let soak for a few
minutes.