EasyManua.ls Logo

Cornelius ABS Basic - User Manual

Cornelius ABS Basic
5 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
McDonald’s
®
ABS Basic Daily Operation
Complete Daily Top 10 Checklist:11
Is the conveyor clean?
Is the nozzle and diffuser clean?
Is syrup deflector in place?
Are the cup tubes properly filled?
Are the cup tubes cracked?
Are the cup tubes fingers
damaged or missing?
Is the drip tray clean?
Is the cup locator spring
damaged or missing?
Is the water deflector in place?
Are grabber pads cracked,
loose, worn or torn?
01
02
03
04
05
06
07
08
09
10
01
01 02 04 05 06
07 08 09
12
• Pressing the appropriate size cup
button will rotate the cup tube to
the front for proper filling.
• Load cup tubes properly:
1. fan cups to separate
2. support bottom of tube with
your hand while cup tubes are
being filled. This will prevent
damage to the cup tube fingers.
• Do not over fill cup tubes.
• Overfilling cup tubes past label will
damage cup tube fingers and cause
multiple cups to be pulled by ABS.
• Do not hand pull cups from turret.
• Continuous improper loading,
overfilling and manual pulling of cups
will cause damage to the cup tube
fingers and multiple cups to be
extracted.
• Do not operate ABS with cracked
cup tubes or missing hardware.
This may cause damage to other
major components.
• Press the red “AUTO/MANUAL”
button to place the ABS unit into
“MANUAL” mode.
• “MANUAL” mode prevents ABS
moving parts from operating.
• Remove ice bin lid and fill with ice
cubes.
• Bin cover must rest securely on top
of bin. A covered ice bin will prevent
foreign objects or material from
falling inside.
• Do not overfill.
• Visually inspect grabber pads for
tears, cracks, excessive wear or
loose fit. Replace as needed.
• Do not use any cleaning products on
pads, as it will cause pads to slip off
cups.
For ABS Service Call:
Coca-Cola SMILE Service
1-800-241-COKE
2 6 5 3
• Do not pour coffee or hot liquids into
drain pan, as the plastic drain pan will
develop cracks and leaks.
• Drain pan replacement is very expensive.
• Place the lids onto the cup tubes.
Covered cup tubes prevent foreign
objects or material from falling into
a customer’s cup.
10
• Clear drink orders by pressing the
“UP ARROW” to highlight orders
and pressing enter to clear orders.
• Press the red “AUTO/MANUAL”
button to place the ABS unit into
“AUTOMATIC” mode.
03
© 2008 IMI CORNELIUS
WWW.CORNELIUS.COM
620807805A Revision: B
To order job aid cards contact Coca-Cola Parts: 1-800-638-2653 Part #111099 -or- www.3Wire.com 3Wire Part #1039561

Table of Contents

Questions and Answers

  • K
    Kelly JohnsonAug 17, 2025
    Why are my Cornelius ABS Basic Commercial Food Equipment beverages not cold?
    • C
      Connie BrownAug 18, 2025
      If your Cornelius Commercial Food Equipment beverages are not cold, it could be due to several reasons. First, check if there is ice in the hopper and fill it if empty. Secondly, ensure that the drains are not plugged, causing water to stand on the cold plate; clean the ice bin and flush the drain with warm water. If the master cooling system isn't cooling, it may require professional attention.
  • B
    brandi26Aug 20, 2025
    Why are the drinks from my Cornelius Commercial Food Equipment foamy?
    • N
      Nancy MaysAug 20, 2025
      If the drinks from your Cornelius Commercial Food Equipment are foamy, the issue might stem from a few sources. Start by ensuring the nozzle and syrup diffuser are clean and sanitized. Also, the bulk Coke tank might need sanitizing. Finally, check your C02 levels; if they're low, replace the tank or switch to a backup.
  • R
    richardlopezAug 22, 2025
    Why are beverages from my Cornelius Commercial Food Equipment too sweet?
    • C
      Charles KingAug 23, 2025
      If your Cornelius Commercial Food Equipment is dispensing beverages that are too sweet, it could be due to a few reasons. A plugged filter could be the cause, so try replacing it. If the carbonator isn't working or there's no C02 pressure in the carbonator, or if the valve ratio requires adjusting, it is recommended to call for service.
  • A
    Anthony ShieldsAug 26, 2025
    What to do if beverages from Cornelius ABS Basic are not sweet enough?
    • R
      Ryan CochranAug 26, 2025
      If beverages from your Cornelius Commercial Food Equipment aren't sweet enough, the B.I.B. container might be empty, so replace it. If the valve ratio requires adjusting, it is recommended to call for service.
  • Y
    ysmithAug 28, 2025
    What to do if the ABS unit of Cornelius Commercial Food Equipment will not enter auto mode?
    • E
      Ernest PerezAug 28, 2025
      If the ABS unit of your Cornelius Commercial Food Equipment won't enter auto mode, it could be due to several reasons. You may be out of C02, there might be no POS host cable, or the unit might appear locked up. In any of these cases, reinstall the C02, press Clear, then AUTO, and power off and restart the unit.
  • C
    Christina JenkinsAug 31, 2025
    How to fix ABS system not communicating in Cornelius Commercial Food Equipment?
    • R
      Renee BlackburnAug 31, 2025
      To troubleshoot the ABS system not communicating with your Cornelius Commercial Food Equipment: * Verify that the ABS unit is in AUTOMATIC MODE. If ABS is in MANUAL MODE, switch ABS to AUTOMATIC MODE. * Verify that the ABS unit is enabled in the POS Drink Dispenser setup. * Verify that POS cable is connected to COM2 on the CCU. * Verify that the POS cable is connected to the ABS unit. * Verify all programming is correct. * Verify that no error messages are displayed on the ABS unit. * Reboot power to the CCU. * Reboot power to the ABS unit.
  • J
    josephrichardsonSep 2, 2025
    Why is the ABS unit dispensing the wrong size or flavor in my Cornelius ABS Basic?
    • J
      Juan WhiteSep 2, 2025
      If your Cornelius Commercial Food Equipment ABS unit is dispensing the wrong size or flavor, ensure that the order in which the flavors and sizes are the same in Flavor Setup and Size Setup in the Drink dispenser as it is on the ABS System. If the problem still persists, call your POS vendor for service.
  • C
    Christopher HarringtonSep 5, 2025
    Why is my Cornelius ABS Basic Commercial Food Equipment ABS not dispensing one or more of a size or flavor?
    • C
      Christine HillSep 5, 2025
      If your Cornelius Commercial Food Equipment ABS is not dispensing one or more of a size or flavor, verify the Flavor and Size spelling is the same in both the Flavor and Size setup as it is in the Menu Item Setup. If the problem still persists, call your POS vendor for service.
  • T
    Teresa GomezSep 8, 2025
    What to do if the gate does not open on Cornelius Commercial Food Equipment?
    • G
      goldenscottSep 8, 2025
      If the gate on your Cornelius Commercial Food Equipment does not open or the agitator turns sluggishly, the ice chute may not be installed correctly. Reinstall the ice chute to resolve this issue.
  • C
    Christopher MillerSep 12, 2025
    How to dispense drinks without ice or with extra ice using Cornelius Commercial Food Equipment ABS unit?
    • K
      Karen GreenSep 12, 2025
      To ensure your Cornelius Commercial Food Equipment ABS unit dispenses drinks without ice or with extra ice, make sure the modifier is enabled as “NO”, “W/O”, or “W/OUT” for no ice. For extra ice, the modifier must be enabled as “EXTRA” or “XTRA.”

Cornelius ABS Basic Specifications

General IconGeneral
BrandCornelius
ModelABS Basic
CategoryCommercial Food Equipment
LanguageEnglish

Related product manuals