What does a low/high voltage error mean on my Cornelius Dispenser?
A low/high voltage error on your Cornelius Dispenser indicates that the line voltage is out of specification (205-255 VAC for 60 Hz and 196-265 VAC for 50 Hz). Check the line voltage and correct it.
What are common issues with the fan motor in a Cornelius Dispenser?
Regarding the fan motor of your Cornelius Dispenser, here's what could be wrong: * Bad connection: Check/connect the wiring. * Bad motor: Replace the motor. * Cracked or bent fan blade: Replace the fan blade.
What causes problems with the hot gas valve in a Cornelius Dispenser?
If you're having trouble with the hot gas valve in your Cornelius Dispenser, consider these possibilities: * Miswired: Correct the wiring. * Defective coil: Replace the coil. * Defective product delivery board: Replace the board.
Why won't my Cornelius VIPER Commercial Food Equipment run?
If your Cornelius Commercial Food Equipment isn't running, there are a couple of things to check: * Make sure the unit is properly plugged in. * Check the circuit breaker; it may need to be reset or replaced.
What to do if my Cornelius Commercial Food Equipment has no water pressure?
If you're experiencing no water pressure with your Cornelius Commercial Food Equipment, try the following: * Ensure that the water source is turned on. * Check the filter; it may be blocked and need changing.
What to do if the Barrel Status is OFF on my Cornelius Commercial Food Equipment?
If the Barrel Status is OFF on your Cornelius Commercial Food Equipment, consider the following: * The barrels may not be activated. Turn the barrels to ON or SPIN. * An error may have shut down the barrels. Correct the error and turn the barrels to ON. * The unit might be in diagnostics. Exit diagnostics and turn the barrels ON.
How to fix the “Sleep” display on the Barrel Status menu of my Cornelius VIPER Commercial Food Equipment?
If you're seeing a “Sleep” display on the Barrel Status menu of your Cornelius Commercial Food Equipment, the following might be the cause: * Sleep time is set. Check the programming. * The clock is incorrectly set. Check the programming. * There is no or incorrect wakeup time set. Check the programming.
How to troubleshoot a Cornelius Dispenser that will not run?
If your Cornelius Dispenser unit isn't running, there are several potential causes: * It might not be plugged in; ensure the unit is properly plugged into a functioning outlet. * A circuit breaker may have tripped; try resetting or replacing the circuit breaker. * There might be no power at L1 or L2 on the contactor; check the voltage at the outlet and the wiring to the contactor. * Low voltage at T1 or T2 could be the issue; in this case, replace the contactor.
Why is the compressor not running on my Cornelius Dispenser?
If the compressor in your Cornelius Dispenser isn't running, consider these potential causes: 1. The barrel might not be in ON mode; ensure the barrel is set to ON. 2. There may be no voltage to the compressor; check the power at contactor L1, L2 - T1, T2. 3. There could be bad start components; inspect the components and wiring. 4. The compressor’s thermal overload protector may be open; check the resistance of compressor windings and incoming line voltage. 5. There might be open or shorted compressor windings; check the resistance of the compressor windings. 6. A bad control board could be the issue; troubleshoot and replace if necessary.
What to do if Cornelius Dispenser compressor is running but not cooling?
If the compressor in your Cornelius Dispenser is running but not cooling, the following could be the reasons: * Low refrigerant: Repair the leak and weigh in a new charge. * Restricted condenser/filter: Clean or repair as needed. * Defective condenser fan motor/blade: Repair or replace the fan. * Hot gas valve leaking or open: Replace the valve. * Defective compressor: Repair or replace the compressor.
General| Category | Commercial Food Equipment |
|---|---|
| Manufacturer | Cornelius |
| Model | VIPER |
| Material | Stainless Steel |
| Number of Flavors | 8 |
| Installation | Countertop |
| Frequency | 60 Hz |
| Warranty | 1 year |
To Next Page
