TS-061 Version 05/05 Page 7 of 7
Hints and Tips
(Continued)
Using parts not recommended by the manufacturer can be dangerous. Only
use the appliance for its intended purpose, the production of ice cubes.
Flavoured waters, fruit juice, cordials and similar products must not be used.
The refrigerant gas used in the appliance (R134a) is chemical waste. Disposal
of the appliance must be done in an environmentally friendly way. See Page 9
for further information on appliance disposal.
Problems and Malfunctions
If the indicator light on WATERTANK is illuminated red or red/orange the
water tank level is low and requires topping up.
If the L and START indicator lights flash and the appliance bleeps then the Ice
Cube Drawer is not positioned properly. Remove the drawer and replace it in
its recess. There are a number of sensors associated with the Ice Cube
Drawer and the Water Tank and faulty positioning of these units is the most
common cause of malfunction. Always ensure that the Ice Cube Drawer and
the Water Tank are correctly positioned in their recesses.
If the M indicator is illuminated and the appliance bleeps, or the M indicator is
flashing and the appliance is not bleeping, the ice cube production process is
stuck. It may be that ice cubes are stuck to the freezer element, an ice cube is
stuck in the mechanism or the ice cubes have fused into one large block of
ice. If this happens switch off the appliance, unplug it from the mains supply,
open the cover and leave it open until all ice blockages melt. Once everything
has melted close the cover, plug the appliance in to the supply, switch on and
press START.
In the event of any appliance stoppages, malfunctions or indicator light
sequences not already covered in these instructions switch the appliance off
for one minute and then switch it on again. This should clear any spurious
faults.
For any faults which cannot be cleared and for further assistance and service
the contact information is shown on the next page.
To Next Page
Loading...
