EasyManua.ls Logo

Cornelius Xtreme ICE XAC 322 User Manual

Cornelius Xtreme ICE XAC 322
29 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
Owner / Operator Manual
IMI Cornelius Inc.
Release Date: October 28, 2005
Revision Date: December 22, 2005
Publication Number: 630460146OPR
Revision: A
www.cornelius.com
IMPORTANT:
TO THE INSTALLER.
It is the responsibility of
the Installer to ensure that
the water supply to the
dispensing equipment is
provided with protection
against backflow by an air
gap as defined in
ANSI/ASME A112.1.2-1979;
or an approved vacuum
breaker or other such
method as proved effective
by test.
Water pipe connections
and fixtures directly
connected to a potable
water supply shall be
sized, installed, and
maintained according to
Federal, State, and Local
Codes.
THIS DOCUMENT CONTAINS IMPORTANT INFORMATION
This Manual must be read and understood before installing or
operating this equipment
Question and Answer IconNeed help?

Do you have a question about the Cornelius Xtreme ICE XAC 322 and is the answer not in the manual?

Cornelius Xtreme ICE XAC 322 Specifications

General IconGeneral
ModelXAC 322
TypeIce Maker
Ice TypeCube
Ice Storage Capacity100 lbs
Ice Cube Size7/8" x 7/8" x 7/8"
Voltage115V
RefrigerantR404A
Power SupplyElectric

Summary

Important Safety Notes

Equipment Specifications

General Information

Technical Specifications Overview

Key physical and operational parameters of the ice machine, such as cube size and temperature ranges.

Installation Instructions

Plumbing Connections

Requirements for water supply lines, drain lines, and pressure to ensure code compliance.

Electrical Connections

Guidelines for wiring, circuit protection, grounding, and manual disconnect for safe operation.

Start Up Sequence

Steps for the initial power-on, system checks, and defrost cycle of the ice machine.

Operation

Normal Operational Cycles

Description of standard operating cycles, including fill, pre-chill, freeze, and harvest.

Primary Start Up Sequence

Detailed steps for initial power-on, system checks, and the hot gas defrost cycle.

Freeze Cycle Process

Explanation of the freeze cycle, including water level monitoring and batch harvesting.

Harvest Cycle Process

Description of the harvest cycle, hot gas solenoid operation, and proximity switch monitoring.

Self Diagnostics Flash Codes (300-1200 Series)

Table correlating LED flash codes to specific system shutdowns or warnings for 300-1200 series.

Self Diagnostics Flash Codes (1400-1800 Series)

Table correlating LED flash codes to specific system shutdowns or warnings for 1400-1800 series.

Clean Cycle Procedure

Detailed steps for initiating and completing the cleaning cycle for the ice machine.

Maintenance

Cleaning the Interior Components

Instructions for cleaning internal parts using approved cleaners like Calgon Nickel Safe.

Cleaning Water System and Evaporator

Detailed steps for cleaning the water system, including distributor tube and evaporator.

Sanitizing Water System and Evaporator

Procedure for sanitizing the ice machine's water system and evaporator using bleach or sanitizer.

Before Calling for Service

Troubleshooting Checklist

A systematic guide to diagnose and resolve common ice machine operational issues.

Related product manuals