Cornelius Xtreme ICE XWC 322 User Manual

Owner / Operator Manual
IMI Cornelius Inc.
Release Date: October 28, 2005
Revision Date: December 22, 2005
Publication Number: 630460146OPR
Revision: A
www.cornelius.com
IMPORTANT:
TO THE INSTALLER.
It is the responsibility of
the Installer to ensure that
the water supply to the
dispensing equipment is
provided with protection
against backflow by an air
gap as defined in
ANSI/ASME A112.1.2-1979;
or an approved vacuum
breaker or other such
method as proved effective
by test.
Water pipe connections
and fixtures directly
connected to a potable
water supply shall be
sized, installed, and
maintained according to
Federal, State, and Local
Codes.
THIS DOCUMENT CONTAINS IMPORTANT INFORMATION
This Manual must be read and understood before installing or
operating this equipment

Cornelius Xtreme ICE XWC 322 Specifications

General

Model	XWC 322
Type	Modular
Ice Production	322 lbs per day
Refrigerant	R404A
Voltage	115V
Frequency	60Hz
Ice Type	Cube
Water Supply	Potable water connection required
Phase	1
Ice Storage Capacity	None (requires separate bin)

Summary

Model and Serial Location

Model/Serial Number Location

Serial Number Explanation

Installation Instructions

Location of Equipment

Guidelines for choosing an optimal and safe installation site.

Equipment Set-Up

Steps for assembling and positioning the ice bin and cuber unit.

Dispenser Installation

Plumbing Connections

Requirements and guidelines for water supply and drain line connections.

Electrical

Electrical wiring and connection requirements according to codes.

Installation Check Points

A checklist to verify all installation steps and requirements are met.

Start Up Sequence

The initial steps to power on and start the ice machine.

Preventative Maintenance Sequence

Operation

Unit Selection

Normal Operations

Overview of the standard cycles and functions of the ice machine.

Start Up Sequence (Primary)

Detailed steps for the initial power-on and system initialization.

Secondary Start Up

Freeze Cycle

Harvest Cycle

Ice Production Check

Flashing Code for Self Diagnostics (300's, 500's, 600's, 800's, 1000's, and 1200's)

Interprets error codes displayed via LED flashes for troubleshooting.

Flashing Code for Self Diagnostics (1400's and 1800's)

Ice-Making Mode

Harvest Mode

Harvest Button

Clean Button

Clean Cycle

Detailed steps and process for cleaning the ice machine.

Maintenance

General Ice Machine Inspection

Cleaning the Exterior

Cleaning the Condenser

Instructions for cleaning air or water-cooled condensers for efficiency.

Interior Cleaning

Steps for cleaning internal components like the evaporator and water system.

Before Calling for Service

Checklist

A guide to diagnosing common ice machine problems before seeking service.

Safety Limit Feature