Cornelius Xtreme ICE XWC 330 User Manual

Owner / Operator Manual
IMI Cornelius Inc.
Release Date: October 28, 2005
Revision Date: December 22, 2005
Publication Number: 630460146OPR
Revision: A
www.cornelius.com
IMPORTANT:
TO THE INSTALLER.
It is the responsibility of
the Installer to ensure that
the water supply to the
dispensing equipment is
provided with protection
against backflow by an air
gap as defined in
ANSI/ASME A112.1.2-1979;
or an approved vacuum
breaker or other such
method as proved effective
by test.
Water pipe connections
and fixtures directly
connected to a potable
water supply shall be
sized, installed, and
maintained according to
Federal, State, and Local
Codes.
THIS DOCUMENT CONTAINS IMPORTANT INFORMATION
This Manual must be read and understood before installing or
operating this equipment

Cornelius Xtreme ICE XWC 330 Specifications

General

Brand	Cornelius
Model	Xtreme ICE XWC 330
Category	Ice Maker
Language	English

Summary

IMPORTANT SAFETY NOTES

GENERAL

Freight Damage Claims Procedure

Steps to follow to check and file claims for damaged shipments upon delivery.

Technical Specifications

Key operational parameters including dimensions, temperatures, pressures, and refrigerant type.

INSTALLATION INSTRUCTIONS

Location of Equipment

Proper placement for optimal performance and reduced maintenance.

Equipment Set-Up

Steps for setting up the ice bin and cuber, including leveling and unpacking.

Plumbing Connections

Guidelines for connecting water lines, ensuring compliance with codes and proper pressure.

Start Up Sequence

Step-by-step process for the initial startup of the ice machine.

OPERATION

Unit Selection

Configuring unit settings using dip switches for optimal water level and proximity monitoring.

Start Up Sequence (Primary)

Detailed steps for the initial power-on and defrost cycle of the ice machine.

Freeze Cycle

The phase where water freezes onto the evaporator plates.

Harvest Cycle

Process where ice is released from the evaporator plates.

Flashing Code for Self Diagnostics

Troubleshooting guide using error codes displayed by the unit's LEDs.

MAINTENANCE

General Ice Machine Inspection

Checking water fittings, refrigeration tubing, and ensuring proper airflow and clearance.

Cleaning the Condenser

Instructions for cleaning air-cooled and water-cooled condensers to maintain performance.

Cleaning the Interior

Steps for cleaning internal components, including evaporator and water system, using approved cleaners.

Sanitizing the Water System

Procedure to sanitize internal components using bleach or commercial sanitizer.

BEFORE CALLING FOR SERVICE

WARRANTY