Cornelius Xtreme ICE XAC 630 User Manual

Owner / Operator Manual
IMI Cornelius Inc.
Release Date: October 28, 2005
Revision Date: December 22, 2005
Publication Number: 630460146OPR
Revision: A
www.cornelius.com
IMPORTANT:
TO THE INSTALLER.
It is the responsibility of
the Installer to ensure that
the water supply to the
dispensing equipment is
provided with protection
against backflow by an air
gap as defined in
ANSI/ASME A112.1.2-1979;
or an approved vacuum
breaker or other such
method as proved effective
by test.
Water pipe connections
and fixtures directly
connected to a potable
water supply shall be
sized, installed, and
maintained according to
Federal, State, and Local
Codes.
THIS DOCUMENT CONTAINS IMPORTANT INFORMATION
This Manual must be read and understood before installing or
operating this equipment

Cornelius Xtreme ICE XAC 630 Specifications

General

Model	XAC 630
Production Capacity	630 lbs per day
Ice Type	Cube
Power Supply	115V/60Hz/1 Ph
Weight	350 lbs
Refrigerant	R404A
Type	Ice Maker

Summary

Important Safety Notes

Specifications

General

Technical Specifications

Lists cube size, temperature, pressure, and refrigerant type.

Installation Instructions

Equipment Set-Up

Steps for setting up the ice bin and cuber components.

Dispenser Installation

Plumbing Connections

Conformance to codes, valve placement, and water pressure requirements.

Electrical

Wiring, circuit protection, grounding, and manual disconnect requirements.

Installation Check Points

Start Up Sequence

Steps to follow when initially powering on the ice machine.

Operation

Unit Selection

Normal Operations

Outline of the standard operational cycles of the ice machine.

Start Up Sequence (Primary)

Detailed steps for the initial power-on and defrost cycle.

Freeze Cycle

The process of freezing water into ice.

Harvest Cycle

The process of releasing harvested ice.

Ice Production Check

Flashing Code for Self Diagnostics (300's, 500's, 600's, 800's, 1000's, and 1200's)

Diagnostic codes for self-diagnostics for specific model ranges.

Flashing Code for Self Diagnostics (1400's and 1800's)

Diagnostic codes for self-diagnostics for other specific model ranges.

Maintenance

Cleaning the Condenser – Air-Cooled

Cleaning the Condenser – Water-Cooled

Cleaning the Interior

Cleaning Procedure if there is Ice on the Evaporator Plate.

Cleaning the Water System and Evaporator

Sanitizing the Water System and the Evaporator

Before Calling for Service

Safety Limit Feature

Explanation of safety limits and procedures to restart the machine.