EasyManua.ls Logo

Cornelius Xtreme ICE XWC 530 User Manual

Cornelius Xtreme ICE XWC 530
29 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
Owner / Operator Manual
IMI Cornelius Inc.
Release Date: October 28, 2005
Revision Date: December 22, 2005
Publication Number: 630460146OPR
Revision: A
www.cornelius.com
IMPORTANT:
TO THE INSTALLER.
It is the responsibility of
the Installer to ensure that
the water supply to the
dispensing equipment is
provided with protection
against backflow by an air
gap as defined in
ANSI/ASME A112.1.2-1979;
or an approved vacuum
breaker or other such
method as proved effective
by test.
Water pipe connections
and fixtures directly
connected to a potable
water supply shall be
sized, installed, and
maintained according to
Federal, State, and Local
Codes.
THIS DOCUMENT CONTAINS IMPORTANT INFORMATION
This Manual must be read and understood before installing or
operating this equipment
Question and Answer IconNeed help?

Do you have a question about the Cornelius Xtreme ICE XWC 530 and is the answer not in the manual?

Cornelius Xtreme ICE XWC 530 Specifications

General IconGeneral
ModelXWC 530
TypeModular Ice Maker
Production Capacity530 lbs per day
RefrigerantR404A
Ice TypeCube
Condenser TypeAir-Cooled
Voltage115V

Summary

IMPORTANT SAFETY NOTES

INSTALLATION INSTRUCTIONS

INSTALLATION CHECK POINTS

A checklist to verify that all installation steps and requirements have been properly completed.

START UP SEQUENCE

The sequence of operations performed when initially powering on the ice machine.

OPERATION

START UP SEQUENCE (PRIMARY)

Detailed steps for the initial primary startup procedure, including defrost and freeze cycles.

FREEZE CYCLE

Explanation of the core ice formation process on the evaporator.

HARVEST CYCLE

Details the process of releasing ice from the evaporator, typically using hot gas.

ICE PRODUCTION CHECK

Method for measuring and verifying the ice production rate of the machine.

LED INDICATORS

Explains the meaning and function of the various LEDs on the unit's control board.

FLASHING CODE FOR SELF DIAGNOSTICS (300's, 500's, 600's, 800's, 1000's, and 1200's)

A table listing diagnostic flash codes and their corresponding error conditions for specific models.

FLASHING CODE FOR SELF DIAGNOSTICS (1400's and 1800's)

A table listing diagnostic flash codes and their corresponding error conditions for the 1400's and 1800's models.

MAINTENANCE

CLEANING PROCEDURE IF THERE IS ICE ON THE EVAPORATOR PLATE.

Specific steps to follow when ice buildup occurs on the evaporator plate.

CLEANING THE WATER SYSTEM AND EVAPORATOR

Detailed instructions for cleaning the internal water system and evaporator components.

Sanitizing the Water System and the Evaporator

Steps for sanitizing the water system and evaporator after the cleaning process.

BEFORE CALLING FOR SERVICE

SAFETY LIMIT FEATURE

Explains safety limits that stop the machine and the procedure to restart it.

WARRANTY

Related product manuals