CORNING PCH-02U - Tools and Materials Required; Tools; Materials

STANDARD RECOMMENDED PROCEDURE 003-722 | ISSUE 4 | OCTOBER 2015 | PAGE 3 OF 10
Figure 2
3. Tools and Materials Required
3.1 Tools
• Phillips screwdriver
• Flat-tipped screwdriver
• 5/16-in socket or wrench
• 11/32-in socket or wrench
• Needle-nosed pliers
• Cable stripping tools
3.2 Materials
Depending on your application, the following materials may be required:
• Preconnectorized adapter panels
• Universal cable clamp (p/n FDC-CABLE GRND to ground armored cable)
• Buffer tube fanout (BTF) kits
• Splice tray bracket kit (p/n PC2-SPLC-6SR)
KPA-0148
Locations for hook-and-loop strap
Locations for hook-and-loop strap
Removable door lock plug
Rear tray stop latch
Front tray stop latch
Jumper routing clips
Radius control guide
Mounting bracket
(shown in standard
5-in frontal projection)
Note: Top removed for clarity