1.4.3 Turn the MULTI-FUNCTION ADJUSTMENT/SELECTION KNOB to desired
language.
1.4.5 Press the MULTI-FUNCTION ADJUSTMENT/SELECTION KNOB to confirm your
selection.
1.5 UNIT
1.5.1 Turn the MULTI-FUNCTION ADJUSTMENT/SELECTION KNOB until UNITS
screen is displayed.
1.5.2 Push in the MULTI-FUNCTION ADJUSTMENT/SELECTION KNOB. The
selected unit measurement is highlighted.
1.5.3 To change selection, Turn the MULTI-FUNCTION ADJUSTMENT/SELECTION
KNOB to selected desired units’ measurement.
1.5.4 Push in the MULTI-FUNCTION ADJUSTMENT/SELECTION KNOB to confirm
your selection.
1.6 BRIGHTNESS
1.6.1 Turn the MULTI-FUNCTION ADJUSTMENT/SELECTION KNOB until
BRIGHTNESS screen is displayed.
1.6.2 Push in the MULTI-FUNCTION ADJUSTMENT/SELECTION KNOB.
1.6.3 To change selection, Turn the MULTI-FUNCTION ADJUSTMENT/SELECTION
KNOB to selected desired screen brightness.
1.6.4 Push in the MULTI-FUNCTION ADJUSTMENT/SELECTION KNOB to confirm
your selection.
1.7 SOFTWARE VERSION
1.7.1 Turn the MULTI-FUNCTION ADJUSTMENT/SELECTION KNOB until
INFORMATION screen is displayed.
1.7.2 Push in the MULTI-FUNCTION ADJUSTMENT/SELECTION KNOB.
1.7.3 Software version is displayed.
1.7.4 Push the START BUTTON to exit.
1.8 TO PERFORM A RESET BACK TO FACTORY SETTINGS
1.8.1 Turn the MULTI-FUNCTION ADJUSTMENT/SELECTION KNOB until FACTORY
RESET screen is displayed.
1.8.2 Push in the MULTI-FUNCTION ADJUSTMENT/SELECTION KNOB.
1.8.3 Turn the MULTI-FUNCTION ADJUSTMENT/SELECTION KNOB to confirm
desire to do a factory reset.
1.8.4 Push in the MULTI-FUNCTION ADJUSTMENT/SELECTION KNOB to start
factory reset or press the START BUTTON to exit.
2. WIRE FEED WELDING SET-UP
2.1 Press the START BUTTON
2.2 Turn the MULTI-FUNCTION ADJUSTMENT/SELECTION KNOB until the desired
Wire Feed Welding screen is displayed.
2.2.1 MIG Steel - Choose this option if you are MIG welding steel with a shielding gas
or flux core welding steel.
2.2.1.1 Use the MULTI-FUNCTION ADJUSTMENT/SELECTION KNOB to
select your shielding gas. Press the MULTI-FUNCTION
ADJUSTMENT/SELECTION KNOB to confirm your selection.
2.2.1.2 Connect the Weld Power Cable (See Figure 8 or follow the
onscreen visual) to the Positive (+) Weld Output Connection.
Press the MULTI-FUNCTION ADJUSTMENT/SELECTION KNOB
To Next Page
Loading...
