ADJUSTMENT/SELECTION KNOB again to confirm.
2.2.6.1.6 Press the START/HOME BUTTON to exit.
2.2.7 Recalling A MIG Program
2.2.7.1 Go through the MIG welding set up steps above.
2.2.7.2 You can now recall previous parameters saved.
2.2.7.2.1 Press the MULTI-FUNCTION
ADJUSTMENT/SELECTION KNOB to deselect the wire
speed feed parameter adjustments
2.2.7.2.2 Turn the MULTI-FUNCTION
ADJUSTMENT/SELECTION KNOB until you get to
MEMORY LOAD.
2.2.7.2.3 Press the MULTI-FUNCTION
ADJUSTMENT/SELECTION KNOB to access the
MEMORY LOAD.
2.2.7.2.4 Turn the MULTI-FUNCTION
ADJUSTMENT/SELECTION KNOB to choose the file
number you wish to use to load. Press the
MULTI-FUNCTION ADJUSTMENT/SELECTION KNOB
to confirm. Press the MULTI-FUNCTION
ADJUSTMENT/SELECTION KNOB again to confirm.
2.2.7.2.5 Press the PREVIOUS SCREEN button then wait a few
seconds for the display to go into welding mode.
3. DC STICK WELDING SET-UP
3.1 Press the START BUTTON
3.2 Turn the MULTI-FUNCTION ADJUSTMENT/SELECTION KNOB until the STICK
screen is displayed
3.3 Push in the MULTI-FUNCTION ADJUSTMENT/SELECTION KNOB to confirm your
selection.
3.4 Follow the display set-up
3.4.1 Connect the Electrode Holder to the Positive (+) Weld Output Connection
3.4.2 Connect the Ground Cable to the Negative (-) Weld Output Connection
3.5 This machine is now set to weld.
3.6 AMPERAGE Adjustment: Turn the MULTI-FUNCTION ADJUSTMENT/SELECTION
KNOB.
3.6.1 Counterclockwise to decrease amperage
3.6.2 Clockwise to increase amperage
3.6.2.1 Note that you will only be able to adjust the amperage to within the
available welding range. Keep in mind that this amperage range is
different when using 120V power and 230V power.
3.7 HOT START
3.7.1 Press the MULTI-FUNCTION ADJUSTMENT/SELECTION KNOB to exit the
Amperage Adjustment Mode.
3.7.2 Turn the MULTI-FUNCTION ADJUSTMENT/SELECTION KNOB to HOT START.
Press to confirm.
3.7.3 Turn the MULTI-FUNCTION ADJUSTMENT/SELECTION KNOB to adjust the HOT
To Next Page
Loading...
