Clear or replace torch liner.
Connect shielding gas supply and turn
shielding gas on.
MIG torch is not correctly installed and
shielding gas is not transferring to the arc.
Remove and reconnect the MIG torch to
make certain it is completely installed into
the MIG connector.
Wire speed setting is incorrect.
Refer to the label inside the wire
compartment door for wire speed setting
recommendations.
Voltage setting is incorrect.
Refer to the label inside the wire
compartment door for voltage setting
recommendations.
For Assistance, Contact The Welder Help Line at 888-762-4045.
To Next Page
Loading...
