LCD SYNERGIC CONTROL
The LCD Synergic Control sets and operates the welder based on selections the operator makes in
weld process and material selections.
MIG TORCH
The welding wire is driven through the welding cable and torch to the work piece. It is attached to the
drive system. The trigger activates the drive motor.
TIG TORCH (OPTIONAL WITH MMWMP242DVIB)
The TIG torch transfers welding power from the welding power source to the tungsten for the
purpose of TIG welding. It also delivers the shielding gas from the welding power source to the
SPOOL GUN (OPTIONAL WITH MMWMP242DVIB)
The Spool Gun is typically used for welding aluminum. The soft aluminum wire has a hard time feeding
consistently in the standard MIG torch. Load 4in. spools of aluminum wire in the spool gun for easy and
consistent feeding of aluminum wire.
ELECTRODE HOLDER AND CABLE
The Electrode Holder holds the stick welding electrode. The cable most often connects to the Positive (+)
weld output connection for stick welding.
To Next Page
Loading...
