3.
Loading batteries
The battery case is placed
at
the
back
of
the
heater cabinet. Put
two
batteries in
the
battery case according
to
the
(
+)
and
(-)
polar,ity marks.
FILLING FUEL TANK WITH FUEL
A WARNING:
USE
ONLY WATER CLEAR N0.1-K KEROSENE (ASTM 1-K)
OR
SYNTHETIC FUELS
FOR
USE
WITH
KEROSENE-FIRED
PORTABLE HEATERS. THE
USE
OF ANY SUBSTANCE
OTHER
THAN
KEROSENE
OR
SYNTHETIC FUELS COULD RESULT IN
AN
EXPLOSION
OR
ARE.
A WARNING:
NEVER
ALL
HEATER FUEL TANK
IN
LIVING SPACE.
ALL
HEATER TANK
OUTDOORS.
TURN
THE HEATER "OFF"
BEFORE
REMOVING
THE FUEL TANK
FOR
REALUNG.
1. Open
the
fuel
tank
access door and
take
out
the
cartridge
tank
.
2. Place
the
cartridge
tank
out
of
harm's way in
the
open with
the
fuel feeding
cap
upside.
3. Detach
the
fuel feeding
cap
by turning
it
counterclock-wise.
4.
Fill the cartridge tank with fuel using the siphon pump, which is placed in the carton, according
to
the
following procedure:
1)
Put the straight tube into the fuel container and
the
flexible tube into the cartridge tank.
2)
Tighten the valve
cap
on the
top
of the grip (see illustration below).
3)
Squeeze the grip
to
let fuel flow into the cartridge
tank
.
4)
When fuel is filled almost
to
the middle point of the fuel gauge, loosen the valve
cap
of
the
grip
and then the
fuel flow will come
to
a stop.
0 )(
@ @
rr
GOOD OVER-FILLED
Note:
When the fuel gauge turns black halfway up,
it
indicates
that
the
cartridge
tank
is filled with
right amount of
fuel. Do not fill beyond this level.
5. Replace the fuel feeding cap on the
tank
and tighten it. Clean up all fuel spills.
6. Put
the
cartridge
tank
back in
the
heater.
- 5 -
To Next Page
Loading...
